Authorised Distributors for Optimate // Accumate battery optimisers and chargers.
If you like the option of a single charger for 6 & 12 Volt batteries, AccuMate 612 is for you. Select the voltage, hook it up to the battery & this reliable, temp’ compensated, 4-stage charger will do the rest. The 4-stage program is ideal for starter & deep cycle / stand-by batteries where a 100% full charge is required for maximum delivery.
FULLY AUTOMATIC SMART CHARGER – hook it up and walk away. AccuMate 612 will fully recharge your battery and then maintain it safely.
1.2A CHARGE CURRENT – delivered constantly right up to the final stage to ensure the quickest charge.
LONG TERM STORAGE – hook it up and AccuMate 612 will maintain your battery at the correct voltage to prevent sulfation for as long as you need to store the vehicle.
BATTERY SIZE: 4Ah to 75Ah
FOR ALL 6V & 12V LEAD-ACID BATTERIES – such as flooded / filler cap; sealed; AGM (absorbed glass mat); GEL.
Integral electronic protections against short circuits at the clamps and wrong polarity connections. Spark suppression system. No fuses to burn.
Approved by ITS to UL & CSA safety standards for battery chargers.
2 year limited warranty. £45.99 Inc Vat
OptiMate 4: The new benchmark – A truly unique diagnostic battery optimizer for 12V lead-acid batteries (sealed maintenance-free, gel, or filler caps) up to 50Ah.
Like all OptiMate models before it, the microprocessor controlled OptiMate 4 can save neglected batteries, but the OptiMate 4 is even more effective, with a new dual-stage RECOVERY + TURBO RECOVERY desulfating action. For neglected deep-discharged batteries the RECOVERY mode engages automatically, while the TURBO RECOVERY mode engages for more severely neglected batteries
**. Like all other OptiMates, the OptiMate 4 then charges the battery, verifies that the battery is as fully charged as its basic state of health allows, and then checks for & detects dead battery cells.
Now OptiMate 4 also has the following new features :-
Maximum output current increased to 0,8A without increasing energy consumption
48 hour time limit on stages up to the first of the cyclic tests for battery drain to avoid wasting time and energy on batteries with a shorted-out cell
19 possible LED indications displayed on 10 LEDs on the stunning new control panel
5 possible results of the cyclic hourly tests for power drain /retention are displayed on a combination of green, yellow & red TEST LEDs
IP64 weatherproof sealed enclosure with built-in mounting option (replaceable if damaged for example by over-tightening a fixing screw)
New cable bushings avoid insulation stress in ultra-cold temperatures
New SAE weatherproof connections.
But, the most important attribute of the OptiMate 4, as with all OptiMates, is the safe, optimal maintenance of your battery during long term storage, achieved by its gentle maintenance cycle which automatically allows the battery to rest for 30 minutes of each hour of the maintenance cycle while it remains connected.
The automatic multi stage program engages as soon as the OptiMate is connected to a 12V battery that has at least 2V :-
The OptiMate 4 immediately checks if the battery has enough voltage to start the program, and whether the battery is deep-discharged ("sulfated") or not.
For neglected batteries, the OptiMate 4 starts the recovery mode, initially limiting the applied voltage at 16V, and if necessary for sulfated batteries, engaging TURBO recovery at a voltage of up to 22V** at low current for up to 2 hours, to recover the battery to a condition in which it can accept a normal charge.
As soon as the circuit detects that this point has been reached (immediately for most batteries), the “bulk charge” mode engages and delivers current at a constant rate of 0,8A to charge the battery.
When the battery-sensing circuit observes that charge progress is sufficient, the unique ‘verification’ stage engages. The voltage is limited at a lower level, & if sensed necessary, a voltage pulsing action provides further desulfating & tops off the charge. When this has been verified, or if after 48 hours from connection the battery has been unable to accept & retain adequate charge, the next stage engages.
The OptiMate then stops current to the battery for 30 minutes while it monitors the unsupported battery voltage to check whether the battery can retain sufficient charge to crank an engine, before the long term maintenance and test cycle begins.
During the next 30 minutes the OptiMate offers the battery a supporting & maintaining charge, but only to the extent necessary to counter any losses or connected loads such as an electronic alarm or immobilizer. Overcharging and/or overheating of the battery is ruled out by this 50% duty cycle as the battery is interactively maintained for 30 minutes and then rests during the power drain tests of each alternative 30 minutes. So the battery is always 100% good to go, but never overcharged.
**The OptiMate’s high voltage desulfation mode cannot engage unless the battery is first disconnected from the vehicle’s electrical system. However, even if the battery is not disconnected, the OptiMate cannot damage sensitive vehicle electronics as the higher voltage mode can only engage if minimal or zero current is flowing into the battery.
Meets all relevant UL & CSA standards.
Comprehensive selection of SAE connection accessories including an output extension set.
2 year limited warranty. £54.04 Inc VAT
Both Kits come with permanent wiring in facility and traditional speed connection. Permanent fixing can usually be done a on a while you wait basis at extra charge.
01691 610 777
